Operating and Installation Instructions
Table Of Contents
- Contents
- IMPORTANT SAFETY INSTRUCTIONS
- Caring for the environment
- Installation information
- Installation dimensions
- Building in the appliance
- Before starting...
- Tools required
- Aligning the installation niche
- Checking the installation space
- Before installation
- Preparing the installation niche
- Pushing the appliance into the niche
- Aligning the appliance
- Securing the appliance in the niche
- Securing the base cover plate and the baseboard
- Aligning the appliance doors
- Adjusting the door opening angle (optional accessory)
- Electrical connection
- Water connection
- How to save energy
- Guide to the appliance
- Accessories
- Before first use
- Switching on and off
- Selecting additional settings
- The correct temperature
- Using Automatic SuperCool and SuperFreeze
- Temperature and door alarm
- Adjusting the interior fittings
- Storing food in the refrigerator section
- Storing food in the MasterFresh zone
- Freezing and storing food
- Making ice cubes
- Automatic defrosting
- Cleaning and care
- Frequently Asked Questions
- Causes of noises
- Water filter
- Technical Service
- Declaration of conformity
- Leere Seite
Adjusting the interior fittings
83
Removing the hanging drawer
The hanging drawer can be moved to
the left or right if required.
To clean the hanging drawer, remove it
as follows:
Pull the hanging drawer straight out
to lift it over the pull-out stops.
To reinsert the hanging drawer, push
it straight into the guide.
Removing compartments from
the Fridge Zone
The compartments in the Fridge Zone
are on telescopic runners, and can be
removed for filling, emptying, or clean-
ing purposes:
Pull the compartment out a little bit.
Using both hands, grasp the com-
partment frame from below and push
the compartment downwards so that
the rear end disengages and lifts up-
wards.
Pull the compartment forwards to re-
move it.
Push the runners back in again to
avoid damaging them!
Be careful not to wash away the spe-
cial lubricant in the telescopic run-
ners during cleaning.
Wipe the telescopic runners with a
damp cloth to clean them.
To reinsert the compartment, position
it on the telescopic runners so that it
clicks into place.