Operating and Installation Instructions
Table Of Contents
- Contents
- IMPORTANT SAFETY INSTRUCTIONS
- Caring for the environment
- Installation information
- Installation dimensions
- Building in the appliance
- Before starting...
- Tools required
- Aligning the installation niche
- Checking the installation space
- Before installation
- Preparing the installation niche
- Pushing the appliance into the niche
- Aligning the appliance
- Securing the appliance in the niche
- Securing the base cover plate and the baseboard
- Aligning the appliance doors
- Adjusting the door opening angle (optional accessory)
- Electrical connection
- Water connection
- How to save energy
- Guide to the appliance
- Accessories
- Before first use
- Switching on and off
- Selecting additional settings
- The correct temperature
- Using Automatic SuperCool and SuperFreeze
- Temperature and door alarm
- Adjusting the interior fittings
- Storing food in the refrigerator section
- Storing food in the MasterFresh zone
- Freezing and storing food
- Making ice cubes
- Automatic defrosting
- Cleaning and care
- Frequently Asked Questions
- Causes of noises
- Water filter
- Technical Service
- Declaration of conformity
- Leere Seite
Adjusting the interior fittings
84
Removing the freezer baskets
The freezer baskets can also be re-
moved if necessary (e.g., for cleaning).
Open the lower appliance door as
wide as possible.
Pull the freezer basket out as far as it
will go.
Raise the snap fastening on both
sides, unclip, and carefully lift the
basket out.
To replace it, pull the telescopic run-
ners out as far as they will go.
Place the freezer basket back in
again.
Slide the basket all the way back in
again until it engages in the snap fas-
tening.
Removing the dividing panel (de-
pending on the model)
The dividing panel in the freezer basket
can be removed for cleaning:
The dividing panel is secured to the
freezer basket with brackets.
Pull the freezer basket out as far as it
will go.
To release the brackets, use a suit-
able object to turn the slots in the
pegs to a horizontal position(1.).
Remove the pegs from the brack-
ets(2.).
Pull the dividing panel upwards to re-
move it.
To reinsert the partition wall, place
the brackets in an upright position,
and position the dividing panel into
the brackets so that you hear it click
into place.
Insert the pegs into the brackets, and
use a suitable object to turn the slots
in the pegs into a vertical position.
Push the freezer basket all the way
back in.