Installation instructions

Changing over the doors:
^
Remove cover a by pulling it
forwards.
^ Pull cover b off.
^ Screw the foot into hinge pin c as far
as it will go.
^ With the help of another person,
carefully tilt the appliance backwards
and pull hinge pin c downwards and
then forwards and out. Take care not
to lose hinge bush d.
^ Undo screws e and take hinge plate
f off.
^
Remove cover g and fit it into the
holes on the opposite side.
^
Undo the screw of hinge part h on
hinge plate f slightly. Turn it into the
hole opposite in hinge plate f and
tighten up the screw.
^
Screw hinge plate f into position on
the opposite side using the two outer
long slots only. Do not use the middle
hole because you will not be able to
align the door later on.
^ Refit cover b.
^ With the help of another person,
carefully tip the appliance back and
refit hinge pin c from below into
hinge plate f on the left hand side.
The notch at the bottom of the hinge
pin should face forwards.
^
Replace hinge bush d on hinge pin
c.
^
Refit cover a on the left making sure
that it clicks into position at both
sides.
^
Place the lower door onto hinge pin
c from above.
^
Close the lower appliance door.
Changing the door hinging
45