Operating instructions/Installation instructions
Table Of Contents
- Contents
- Warning and Safety instructions
- Caring for the environment
- Saving energy
- Guide to the appliance
- Accessories
- Switching on and off
- The correct temperature
- Using Super freeze and Dynamic cooling
- Temperature and door alarm
- Selecting further settings
- Storing food in the refrigerator section
- Adjusting the interior fittings (refrigerator section)
- Freezing and storing food
- Defrosting
- Cleaning and care
- Cleaning agents
- Preparing the refrigeration appliance for cleaning
- Cleaning the interior and accessories
- Cleaning the front of the appliance and the side panels
- Cleaning the ventilation gaps
- Cleaning the compressor and metal grille at the back of the appliance
- Cleaning the door seal
- After cleaning
- Replacing the charcoal filters
- Problem solving guide
- Noises
- Service
- Installation
Using Super freeze and Dynamic cooling
28
DynaCool function
When the dynamic cooling (DynaCool)
function is not switched on, the natural
circulation of air in the appliance will
cause different temperature zones in
the refrigerator section, as the cold,
heavy air will sink to the lowest section
of the appliance. You should bear this in
mind when placing food in the
appliance (see “Storing food in the
refrigerator section”).
However, if you are placing a large
amount of food in the refrigerator (e.g.
for a party), it is a good idea to switch
on DynaCool. This will distribute the
temperature in the appliance to all areas
more evenly so that all the food is
chilled to about the same degree.
The temperature is set as normal with
the temperature control.
DynaCool should also be selected for
the following conditions:
- The ambient temperature in the room
is high (above approx. 30°C).
- The humidity levels are high (e.g. in
the summer).
The DynaCool functiuon can be
switched on if the temperature in the
refrigerator section is visible in the
temperature display.
Switching on DynaCool
Briefly press the button.
The symbol lights up.
The fan is now ready for operation and
will switch on automatically when the
compressor is running.
Switching off DynaCool
As the energy consumption increases
when DynaCool is switched on, you
should turn it off under normal
conditions.
Press the button so that the
symbol goes out.
To save energy, the fan switches off
automatically whilst the door is open.