Operating instructions/Installation instructions
Table Of Contents
- Contents
- Warning and Safety instructions
- Caring for the environment
- Saving energy
- Guide to the appliance
- Accessories
- Switching on and off
- The correct temperature
- Using Super freeze and Dynamic cooling
- Temperature and door alarm
- Selecting further settings
- Storing food in the refrigerator section
- Adjusting the interior fittings (refrigerator section)
- Freezing and storing food
- Defrosting
- Cleaning and care
- Cleaning agents
- Preparing the refrigeration appliance for cleaning
- Cleaning the interior and accessories
- Cleaning the front of the appliance and the side panels
- Cleaning the ventilation gaps
- Cleaning the compressor and metal grille at the back of the appliance
- Cleaning the door seal
- After cleaning
- Replacing the charcoal filters
- Problem solving guide
- Noises
- Service
- Installation
Adjusting the interior fittings (refrigerator section)
36
Adjusting the door/bottle shelf
Only move door/bottle shelves when
they are empty.
Push the door/bottle shelf upwards,
then remove it by pulling it forwards.
Replace the shelf at the required
height. Ensure that it is securely
pushed back into position.
Moving the shelves
Stoppers prevent the shelves from
being dislodged by mistake.
The shelves can be adjusted
according to the height of the
refrigerated goods:
1. Lift it up slightly at the front.
2. Remove it from the appliance.
The raised edge on the protective strip
at the back must face upwards to
prevent food from touching the back
of the appliance and freezing to it.
Replace it on the level you want.
Adjusting or removing the
bottle holder
The bottle holder can be moved left or
right to create more room for drink
cartons.
The bottle holder can be removed
completely (e.g. for cleaning):
Pull the bottle holder upwards to
remove it from the rear edge of the
bottle shelf.
The bottle holder can be replaced after
cleaning.