Operating instructions/Installation instructions
Table Of Contents
- Contents
- Warning and Safety instructions
- Caring for the environment
- Saving energy
- Guide to the appliance
- Accessories
- Switching on and off
- The correct temperature
- Using Super freeze and Dynamic cooling
- Temperature and door alarm
- Selecting further settings
- Storing food in the refrigerator section
- Adjusting the interior fittings (refrigerator section)
- Freezing and storing food
- Defrosting
- Cleaning and care
- Cleaning agents
- Preparing the refrigeration appliance for cleaning
- Cleaning the interior and accessories
- Cleaning the front of the appliance and the side panels
- Cleaning the ventilation gaps
- Cleaning the compressor and metal grille at the back of the appliance
- Cleaning the door seal
- After cleaning
- Replacing the charcoal filters
- Problem solving guide
- Noises
- Service
- Installation
Cleaning and care
49
After cleaning
Replace all shelves and accessories
in the appliance.
Switch the refrigeration appliance on.
Switch on the Super freeze function
for a while so that the freezer section
can cool down quickly.
Place food in the refrigerator section
and close the door.
Place the freezer drawers with the
frozen food back in the freezer
section and close the door.
When the temperature in the freezer
section is a constant -18°C or colder
press the Super freeze button to
switch the Super freeze function off.
Replacing the charcoal filters
Charcoal filters and a KKF-FF (Active
AirClean) holder are available as
optional accessories (see
“Accessories - optional accessories”).
Replace the charcoal filters in the
holder every 6months.
Replacement KKF-RF charcoal filters
can be obtained from the Miele
Customer Service Department, from
your retailer or from Miele's website.
Tip: The charcoal filter holder is
dishwasher-safe.
Pull the charcoal filter holder upwards
to remove it from the adjustable shelf.
When in position, the charcoal filters
must not touch the rear wall of the
refrigeration appliance as the
moisture could cause them to stick
to it.
Insert the new charcoal filters deep
enough in the holder to ensure that
they do not protrude over the edge
of the holder.