Operating instructions/Installation instructions
Table Of Contents
- Contents
- Warning and Safety instructions
- Caring for the environment
- Saving energy
- Guide to the appliance
- Accessories
- Switching on and off
- The correct temperature
- Using Super freeze and Dynamic cooling
- Temperature and door alarm
- Selecting further settings
- Storing food in the refrigerator section
- Adjusting the interior fittings (refrigerator section)
- Freezing and storing food
- Defrosting
- Cleaning and care
- Cleaning agents
- Preparing the refrigeration appliance for cleaning
- Cleaning the interior and accessories
- Cleaning the front of the appliance and the side panels
- Cleaning the ventilation gaps
- Cleaning the compressor and metal grille at the back of the appliance
- Cleaning the door seal
- After cleaning
- Replacing the charcoal filters
- Problem solving guide
- Noises
- Service
- Installation
Installation
*INSTALLATION*
62
Installing the refrigeration appliance
Danger of injury and damage
due to the refrigeration appliance
tipping over.
There is an increased danger of
injury and damage if the refrigeration
appliance is installed by a single
person.
Two people are required for installing
the refrigeration appliance.
Risk of damaging the floor.
Moving the refrigeration appliance
can cause damage to the floor.
Move the refrigeration appliance
carefully on floors that are sensitive
to scratching.
For easier installation there are
transport handles on the back at the
top and transport wheels underneath
the refrigeration appliance.
Tip: The refrigeration appliance must be
empty when it is installed.
Prepare the refrigeration appliance for
installation as close as possible to its
intended installation location.
Release the mains cable from the
back of the appliance.
Remove the cable clip from the back
of the appliance.
Move the refrigeration appliance
carefully to its intended installation
location.
Position the refrigeration appliance
with the wall spacers (if used) or the
back close to the wall.
Aligning the appliance
To align the appliance, adjust the
front feet using the spanner supplied
Levelling the appliance door
Risk of damage and injury
caused by the appliance door falling
out or the refrigeration appliance
tipping over.
If the additional adjustable foot on
the hinge plate at the bottom is not
resting firmly on the floor, the
appliance door can fall out or the
refrigeration appliance can tip over.
Use the open spanner supplied with
the appliance to unscrew the
adjustable foot until it is resting on
the floor.
Then unscrew the adjustable foot by
a further quarter turn.