Operating instructions/Installation instructions
Table Of Contents
- Contents
- Warning and Safety instructions
- Caring for the environment
- Saving energy
- Guide to the appliance
- Accessories
- Switching on and off
- The correct temperature
- Using Super freeze and Dynamic cooling
- Temperature and door alarm
- Selecting further settings
- Storing food in the refrigerator section
- Adjusting the interior fittings (refrigerator section)
- Freezing and storing food
- Defrosting
- Cleaning and care
- Cleaning agents
- Preparing the refrigeration appliance for cleaning
- Cleaning the interior and accessories
- Cleaning the front of the appliance and the side panels
- Cleaning the ventilation gaps
- Cleaning the compressor and metal grille at the back of the appliance
- Cleaning the door seal
- After cleaning
- Replacing the charcoal filters
- Problem solving guide
- Noises
- Service
- Installation
Installation
*INSTALLATION*
68
Undo the screws and remove
lower hinge plate together with
hinge pin, plastic disc and the
adjustable foot.
Unscrew the hinge pin together
with plastic disc, and screw back
into the opposite hole in the the hinge
plate.
Carefully remove cover and refit on
the opposite side.
Screw the lower hinge plate
together with hinge pin, plastic
disc and the adjustable foot in
on the opposite side.
Lower the lower door onto the hinge
pin .
Close the appliance door.
Fit hinge plate turned through 180°
into the bearing bush in the lower
door. Important! Make sure the
plastic disc is fitted back on the
hinge pin.
Then screw the hinge plate on
securely with screws.
Place the upper door onto the hinge
pin from above.
Fit hinge plate turned through 180°
into the bearing bush in the upper
door.
Then screw the hinge plate on
securely with screws.
Fit cover back onto the opposite
site. It will click into position.
Fit cover back onto the opposite
site. It will click into position.
Unscrew adjustable foot from the
lower hinge plate until it sits on the
floor.