Operating instructions/Installation instructions
Table Of Contents
- Contents
- Warning and Safety instructions
- Caring for the environment
- Saving energy
- Guide to the appliance
- Accessories
- Switching on and off
- The correct temperature
- Using Super freeze and Dynamic cooling
- Temperature and door alarm
- Selecting further settings
- Storing food in the refrigerator section
- Adjusting the interior fittings (refrigerator section)
- Freezing and storing food
- Defrosting
- Cleaning and care
- Cleaning agents
- Preparing the refrigeration appliance for cleaning
- Cleaning the interior and accessories
- Cleaning the front of the appliance and the side panels
- Cleaning the ventilation gaps
- Cleaning the compressor and metal grille at the back of the appliance
- Cleaning the door seal
- After cleaning
- Replacing the charcoal filters
- Problem solving guide
- Noises
- Service
- Installation
Adjusting the interior fittings (refrigerator section)
34
Adjusting the bottle rack
The bottle rack can be placed at
different positions in the appliance.
Raise the bottle rack slightly at the
front, and pull it forwards a little until
the notch at the side is in line with the
shelf support. It can then be raised or
lowered to the required level.
The rear rail must face upwards to
prevent bottles from touching the back
of the appliance.
Stoppers prevent the bottle rack from
being dislodged by mistake.
Moving the charcoal filters
Charcoal filters and a KKF-FF (Active
AirClean) holder are available as
optional accessories (see
“Accessories - optional accessories”).
When storing very strong smelling
food (e.g. very ripe cheese):
- Place the holder with the charcoal
filters on the shelf where this food is
kept.
- Change the filters sooner if
necessary.
- Use more charcoal filters (with
holders) in the appliance (see
“Accessories – Optional
accessories”).
The holder for the charcoal filters sits
on the protective strip at the back of the
shelf.
To move the charcoal filters, pull the
holder upwards to remove it from the
protective strip.
Refit the holder on the protective strip
of the shelf you wish to use it on.