Operating instructions/Installation instructions
Table Of Contents
- Contents
- Warning and Safety instructions
- Caring for the environment
- Saving energy
- Guide to the appliance
- Accessories
- Switching on and off
- The correct temperature
- Using Super freeze and Dynamic cooling
- Temperature and door alarm
- Selecting further settings
- Storing food in the refrigerator section
- Adjusting the interior fittings (refrigerator section)
- Freezing and storing food
- Defrosting
- Cleaning and care
- Cleaning agents
- Preparing the refrigeration appliance for cleaning
- Cleaning the interior and accessories
- Cleaning the front of the appliance and the side panels
- Cleaning the ventilation gaps
- Cleaning the compressor and metal grille at the back of the appliance
- Cleaning the door seal
- After cleaning
- Replacing the charcoal filters
- Problem solving guide
- Noises
- Service
- Installation
Warning and Safety instructions
8
To avoid the risk of damage to the appliance, make sure that the
connection data (fuse rating, frequency and voltage) on the data
plate corresponds to the household supply.
Check that this is the case before connecting the appliance. Consult
a qualified electrician if in any doubt.
The electrical safety of this appliance can only be guaranteed
when correctly earthed. It is essential that this standard safety
requirement is met. If in any doubt please have the electrical
installation tested by a qualified electrician.
Reliable and safe operation of this appliance can only be assured
if it has been connected to the mains electricity supply.
If the electrical connection cable is faulty it must only be replaced
by a Miele authorised service technician to protect the user from
danger.
Do not connect the appliance to the mains electrical supply by a
multi-socket adapter or extension lead. These are a fire hazard and
do not guarantee the required safety of the appliance.
If moisture gets into electrical components or into the mains
connection cable, it could cause a short circuit. Therefore, do not
operate this refrigeration appliance in areas which are exposed to
moisture (e.g in a garage or utility room).
This appliance must not be used in a non-stationary location (e.g.
on a ship).
Do not use a damaged appliance. It could be dangerous. Check
the appliance for visible signs of damage.
This refrigeration appliance is not intended for use as a built-in
appliance.
The appliance must be isolated from the electricity supply during
installation, maintenance and repair work.