Operating instructions/Installation instructions

Problem solving guide
63
Message Cause and remedy
lights up in the dis-
play.
The Replace filter reminder setting has been
activated. This is the reminder to change the filter
(Active AirClean).
 Replace the filter in the holder (see “Cleaning and
care - Replacing the filter”).
 Reset the counter (see “Selecting further settings -
Filter replacement indictor”).
The power failure sym-
bol , appears in the
display and the alarm
tone sounds.
The temperature display
will show the warmest
temperature recorded in
the freezer during a
power failure or an in-
terruption to the power
supply.
Indication of an power failure: the temperature in the
appliance over the last few days or hours has risen
too high because of a power failure or interruption to
the power supply.
The appliance will go back to the last temperature
setting when the power is back on.
 Press the OK button.
The warmest temperature displayed will disappear.
The display will then revert to showing the current
temperature in the freezer section.
 Depending on the temperature displayed, you
should check whether food in the freezer has
started to thaw or has defrosted. If it has, it should
be used as soon as possible. Defrosted food may
only be re-frozen after it has been cooked.
“F0toF9” appears in
the display.
There is a fault.
 Call the Miele Service Department.
“FE*” appears in the dis-
play.
There is a fault.
 Call the Miele Service Department.
The  symbol lights up
in the display, the appli-
ance does not get cold,
although the controls
and the interior lighting
are working.
Demo mode is switched on. This allows the
appliance to be presented in the showroom without
the cooling system being switched on. Do not
activate this setting for domestic use.
 Switch off Demo mode (see “Information for
dealers - Demo mode”).