Operating instructions/Installation instructions

Installation
*INSTALLATION*
105
To enhance the stability of the
appliance in the unit, push the rods
supplied in underneath the appliance
between it and the floor of the housing
unit:
 First secure the handle to one of
the stabilising rods.
 Push the stabilising rod into the
guide hole as far as it will go. Remove
the handle, fit it to the other rod
supplied and push this into its guide
as far as it will go.
Tip: Keep the handle somewhere safe
in case you ever need to fit the
appliance into a new housing unit.
 Close the appliance doors.
Fitting the furniture doors
The upper edge of the appliance
furniture doors should be aligned with
the height of the furniture doors of the
adjacent kitchen units.
The furniture doors must be mounted
free of tension.
The following chapter describes the
installation of furniture doors with a
furniture front of at least 16-19mm
thickness.
Carry out the following steps on both
doors.
 The distance between the appliance
door and the fixing bracket is set to
8mm at the factory. Check this
distance and adjust it if necessary.
 Push the fitting aids up to the
height of the furniture door: the lower
edge X of the fitting aids must be at
the same height as the upper edge of
the furniture door being fitted (see
in diagram).