Operating instructions/Installation instructions

Cleaning and care
62
Rinsing the ice-cube maker
The ice-cube maker and water
supply pipework must be rinsed:
– before using for the first time,
– if the ice-cube maker has not been
used for a long time,
– regularly when in continuous use
(at least once a month), to remove
ice residues from the system (to
avoid a blockage of the water
supply) and
– before switching the ice-cube
maker off for a long time.
After selecting the “Rinse the ice-cube
maker” setting, the ice-cube maker
and the water supply pipework will be
rinsed automatically with water.
The ice-cube tray then rotates into the
cleaning position to allow you to dry it
by hand.
Water is collected in the ice-cube
drawer.
Make sure the ice-cube drawer is
empty before selecting the “Rinse the
ice-cube maker” setting. Otherwise,
the water will empty onto the contents
of the drawer.
The “Rinse ice-cube maker” setting
can only be selected when the ice-
cube maker is switched on.
 Touch the settings button.
All symbols available for selection will
appear in the display and the  symbol
flashes.
 Touch the buttons for setting the
temperature ( and ) repeatedly
until the ice-cube maker symbol
flashes in the display.
 Touch the OK button to confirm your
selection.
 By touching the and  button,
you can now select the setting you
want:
0: the ice-cube maker is switched off
1: the ice-cube maker is switched on
2: set the water volume
3: select the ice-cube tray cleaning
position
4: rinse the ice-cube maker
 Touch the OK button to confirm your
selection.
The selected setting is applied. The
symbol in the display for the ice-cube
maker and the indicator light on the
ice-cube maker will flash while the ice-
cube maker is being rinsed.
You will hear the ice-cube tray turn so
that it is at an angle.
 Wait until the ice-cube tray has
completed this rotation before
continuing.