Operation Manual

Making ice cubes
51
Switching the ice cube maker on and
off
 Touch the settings sensor.
All symbols available for selection will
appear in the display and the symbol
flashes.
 Touch the sensors for setting the
temperature (or ) repeatedly until
the the ice cube maker symbol
flashes in the display.
 Touch the OK sensor to confirm your
selection.
 Use the  and sensors to set the
ice cube maker:
0: Ice cube maker is switched off
1: Ice cube maker is switched on
 Touch the OK sensor to confirm your
selection.
The selected setting is applied.
 Touch the settings sensor to leave
settings mode or
 Close the appliance door.
Otherwise the appliance will switch to
normal operation after approximately
one minute.
Making a large amount of ice cubes
The amount of ice cubes which the ap-
pliance makes depends on the temper-
ature in the freezer section. The lower
the temperature, the more ice cubes are
produced within a certain time frame. At
a temperature of -18°C, approx. 1kg of
ice cubes will be produced within
24hours.
Ice cube production is halted automat-
ically when the ice cube drawer is full.
Tip: If you require a large amount of ice
cubes, replace the full ice cube drawer
with the drawer beside it on the right.
The ice cube maker will begin to pro-
duce ice cubes again as soon as this
new drawer has been placed in position
and closed properly.
Altering the size of the ice cubes
The size of the ice cubes produced de-
pends on the volume of the water in-
take which you can set according to
your requirements. To make larger ice
cubes, the volume of the water intake
must be increased. A medium volume
of water intake(E3) is set as the factory
default.