Operation Manual

Making ice cubes
52
Setting the water volume
The setting can only be selected if the
ice cube maker is switched on.
 Touch the settings sensor.
All symbols available for selection will
appear in the display and the symbol
flashes.
 Touch the sensors for setting the
temperature (or ) repeatedly until
the the ice cube maker symbol
flashes in the display.
 Touch the OK sensor to confirm your
selection.
 By touching the  and  sensor you
can now alter the water volume:
0: the ice cube maker is switched off
1: the ice cube maker is switched on
2: set the water volume
3: select the ice cube tray cleaning
position
4: rinse the ice cube maker
 Touch the OK sensor to confirm your
selection.
 By touching the  or  sensor, you
can now set the water volume you re-
quire (E1 to E8):
E1: low water volume
E8: high water volume
 Touch the OK sensor to confirm your
selection.
The selected setting is applied.
 Touch the settings sensor to leave
settings mode, or
 Close the appliance door.
Otherwise the appliance will switch to
normal operation after approximately
one minute.
Switching the ice cube maker on/off
with the On/Off button
 Pull the ice cube drawer out slightly.
 Press the On/Off button on the ice
cube maker,
– until the indicator light comes on. The
ice cube maker symbol will ap-
pear in the display. The ice cube
maker is switched on.
– until the indicator light goes out. The
ice cube maker symbol will go out
in the display. The ice cube maker is
switched off.
 Close the ice cube drawer.