User manual

Selecting further settings
52
Switching off Demo mode
Demo mode allows the refrigeration
appliance to be presented in the show-
room without the cooling system being
switched on. This setting is not needed
for domestic use.
If Demo mode has been switched on
as a default setting, will show on the
start display.
 Tap.
 Tap.
 Swipe left or right until is shown in
the middle.
 Tap.
After Demo mode has been switched
off, the refrigeration appliance shuts
down and must be switched on again.
Resetting the settings to their default
settings
All settings made on the refrigeration
appliance will be reset to default set-
tings (for settings, see “Guide to the ap-
pliance”).
 Tap.
 Swipe left or right until is shown in
the middle.
 Tap.
will appear on the display.
 Tap OK.
The refrigeration appliance shuts down
and must be switched on again.
Information
Appliance data (model number and
serial number) is shown on the display.
Tip: This data is important when report-
ing an appliance fault to the Miele Cus-
tomer Service Department (see “Ser-
vice”).
Charcoal filter change indicator
After inserting the charcoal filter (op-
tional accessory), you must activate the
charcoal filter change indicator in
Settings mode.
The charcoal filter change indicator
on the start display will remind you to
replace the charcoal filter approx.
every 6months (see “Cleaning and
care – Replacing the charcoal filters”).