Installation instructions

Before using for the first time
The stainless steel trim to the interior
shelves and the door shelves has a
layer of protective foil to prevent
scratching during transportation.
^
Do not remove this foil until the
appliance has been built-in.
^
Treat the stainless steel surfaces with
a proprietary stainless steel
conditioner immediately after
removing the foil (available from the
Miele Spare Parts department or via
the internet on www.miele.co.uk).
Important! A stainless steel
conditioner gives long lasting
protection, and helps to prevent
re-soiling.
^ Clean the inside of the appliance and
the accessories with warm water and
a little washing-up liquid, and then
dry with a soft cloth.
Important:
To ensure the correct functioning of
the appliance, let it stand for
between 1½ and 2 hours after
transporting it to its final location
before connecting it to the mains.
Switching on
The refrigerator and freezer sections are
switched on together by pressing the
master switch on the right hand side of
the control panel.
^
Press the master switch on the right
hand side of the control panel.
The temperature display for the
refrigerator section lights up, and the
interior lighting comes on when the door
is opened.
Bars light up in the temperature display
for the freezer section.
The appliance starts cooling.
To enable the temperature to get
sufficiently cold inside the appliance,
allow the appliance to run for a few
hours before placing food in it.
Cool pack
Place the cool pack in the top freezer
drawer or, to save space, on the freezer
tray. The cool pack will be at its most
effective after it has been in the freezer
for approx. 24 hours.
Switching off
^ Press the master switch on the right
hand side of the control panel until
both temperature displays go out.
The cooling system is switched off. If
this does not happen, then the safety
lock has been activated.
Switching on and off
15