Installation instructions

. . . the Super freeze indicator light
does not light up, even though the
appliance is working.
The indicator light is defective. Call the
Service Department.
. . . you cannot switch the appliance
off.
The safety lock has been activated.
..."nA" appears in the freezer
section temperature display.
The freezer section temperature has
risen too high at some point during the
last couple of days because of a power
cut.
^ Press the alarm off button whilst "nA"
is lit up in the display.
The temperature display will show the
warmest temperature recorded in the
freezer section during the power cut.
Depending on the temperature
displayed, you should check the
condition of food in the freezer. If it has
defrosted or started to defrost, check
that it is still safe to use and if so use it
as soon as possible. Defrosted food
may only be re-frozen after it has been
cooked.
The warmest temperature will show in
the display for about 1 minute. The
display will then revert to showing the
actual current temperature in the
freezer section.
At the end of a power cut, the
appliance will start operating again at
the last temperature setting selected.
. . . you cannot switch the ice cube
maker on.
^
Check whether the appliance is
connected to the electricity supply.
. . . the ice cube maker is not
producing any ice cubes.
^
Was the water inlet pipe purged of air
by a qualified and competent person
before the appliance was used for
the first time?
^
Check whether the ice cube maker is
switched on.
^ Check whether the freezer section is
switched on.
^ Check whether the stopcock is open.
^ Check that the ice cube drawer has
been closed properly.
Remember it can take up to 24 hours to
produce the first ice cubes.
. . . the indicator light on the ice cube
maker is flashing.
There is a fault. Call the Service
Department.
Problem solving guide
42