User's Manual
Table Of Contents
- Contents
- Warning and Safety instructions
- Caring for the environment
- How to save energy
- Guide to the appliance
- Accessories
- Before using for the first time
- Switching on and off
- The correct temperature
- Using SuperFreeze, SuperCool and DynaCool
- Temperature and door alarm
- Selecting further settings
- Settings overview
- Selecting further settings
- Explanation of the different settings
- Switching Party mode on/off
- Switching Holiday mode on/off
- Using the minute minder (QuickCool timer)
- – Setting the minute minder
- – When the minute minder duration has elapsed
- – Altering the minute minder
- – Cancelling the minute minder
- Activating or deactivating the safety lock /
- – Deactivating the safety lock temporarily
- – Switching off the safety lock
- Switching the appliance off
- Switching Sabbath mode on/off
- – Switching Sabbath mode on
- – Switching Sabbath mode off prematurely
- Setting the time before the door alarm is triggered
- Switching the keypad tone / on/off
- Setting the volume/Switching alarms and audible tones on/off
- Setting the display brightness
- Setting the temperature unit /
- Switching Demo mode off
- Resetting factory settings
- Accessing information
- – Displaying licence agreements
- Reminder to replace charcoal filter
- Using the refrigerator efficiently
- Adjusting the interior fittings (refrigerator section)
- Freezing and storing food
- Defrosting
- Cleaning and care
- Cleaning agents
- Preparing the appliance for cleaning
- Cleaning the interior and accessories
- Cleaning the front of the appliance and the side panels
- Cleaning the ventilation gaps
- Cleaning the compressor and metal grille at the back of the appliance
- Cleaning the door seals
- Starting up the appliance after cleaning
- Replacing the charcoal filters
- Problem solving guide
- Noises
- Service
- Electrical connection
- Installation
- Changing the door hinging
- Aligning the appliance doors
Problem solving guide
65
Message Possible cause and remedy
lights up red in the
display, a fault code F
with numbers appears
and an alarm sounds.
There is a fault.
To switch the alarm off touch in the display.
Call Miele.
To report the fault you need the fault code and also
the model number and serial number of your
appliance. You can access these in the display.
To do this touch in the display.
The appliance data required will be shown in the
display.
Confirm with OK to exit the information display, and
the fault code will be shown again in the display.
The appliance can be switched off directly from the
fault code display.
Touch .
There is an appliance fault: This display will override
any settings which have just been selected.
An appliance fault has priority over any current door
and/or temperature alarms in the display.