User's Manual
Table Of Contents
- Contents
- Warning and Safety instructions
- Caring for the environment
- How to save energy
- Guide to the appliance
- Accessories
- Before using for the first time
- Switching on and off
- The correct temperature
- Using SuperFreeze, SuperCool and DynaCool
- Temperature and door alarm
- Selecting further settings
- Settings overview
- Selecting further settings
- Explanation of the different settings
- Switching Party mode on/off
- Switching Holiday mode on/off
- Using the minute minder (QuickCool timer)
- – Setting the minute minder
- – When the minute minder duration has elapsed
- – Altering the minute minder
- – Cancelling the minute minder
- Activating or deactivating the safety lock /
- – Deactivating the safety lock temporarily
- – Switching off the safety lock
- Switching the appliance off
- Switching Sabbath mode on/off
- – Switching Sabbath mode on
- – Switching Sabbath mode off prematurely
- Setting the time before the door alarm is triggered
- Switching the keypad tone / on/off
- Setting the volume/Switching alarms and audible tones on/off
- Setting the display brightness
- Setting the temperature unit /
- Switching Demo mode off
- Resetting factory settings
- Accessing information
- – Displaying licence agreements
- Reminder to replace charcoal filter
- Using the refrigerator efficiently
- Adjusting the interior fittings (refrigerator section)
- Freezing and storing food
- Defrosting
- Cleaning and care
- Cleaning agents
- Preparing the appliance for cleaning
- Cleaning the interior and accessories
- Cleaning the front of the appliance and the side panels
- Cleaning the ventilation gaps
- Cleaning the compressor and metal grille at the back of the appliance
- Cleaning the door seals
- Starting up the appliance after cleaning
- Replacing the charcoal filters
- Problem solving guide
- Noises
- Service
- Electrical connection
- Installation
- Changing the door hinging
- Aligning the appliance doors
Installation
74
Aligning the appliance
To align the appliance, adjust the
front feet using the spanner supplied.
Supporting the appliance door
Ensure that you unscrew the
adjustable foot from the lower
hinge plate with the enclosed
spanner until it sits on the floor. Then
unscrew the foot by a further ¼turn.
Installing the appliance in
existing kitchen units
Risk of fire and damage due to
insufficient ventilation!
If the appliance is not ventilated
sufficiently, the compressor will run
more frequently and for longer
periods. This will result in increased
energy consumption and a higher
operating temperature of the
compressor. This, in turn, can result
in damage to the compressor.
Please ensure that there is adequate
ventilation around the appliance.
It is essential to observe the required
ventilation gaps. The ventilation gaps
must not be covered or blocked in
any way.
The larger the ventilation gap, the
more economically the compressor
will work.
– A ventilation gap of at least 50mm
depth must be provided at the back
of the appliance behind the whole
width of the top box for air to
circulate.
– The ventilation gap under the ceiling
must be at least 300cm
2
to ensure
that the warm air can escape
unhindered.