User's Manual
Table Of Contents
- Contents
- Warning and Safety instructions
- Caring for the environment
- How to save energy
- Guide to the appliance
- Accessories
- Before using for the first time
- Switching on and off
- The correct temperature
- Using SuperFreeze, SuperCool and DynaCool
- Temperature and door alarm
- Selecting further settings
- Settings overview
- Selecting further settings
- Explanation of the different settings
- Switching Party mode on/off
- Switching Holiday mode on/off
- Using the minute minder (QuickCool timer)
- – Setting the minute minder
- – When the minute minder duration has elapsed
- – Altering the minute minder
- – Cancelling the minute minder
- Activating or deactivating the safety lock /
- – Deactivating the safety lock temporarily
- – Switching off the safety lock
- Switching the appliance off
- Switching Sabbath mode on/off
- – Switching Sabbath mode on
- – Switching Sabbath mode off prematurely
- Setting the time before the door alarm is triggered
- Switching the keypad tone / on/off
- Setting the volume/Switching alarms and audible tones on/off
- Setting the display brightness
- Setting the temperature unit /
- Switching Demo mode off
- Resetting factory settings
- Accessing information
- – Displaying licence agreements
- Reminder to replace charcoal filter
- Using the refrigerator efficiently
- Adjusting the interior fittings (refrigerator section)
- Freezing and storing food
- Defrosting
- Cleaning and care
- Cleaning agents
- Preparing the appliance for cleaning
- Cleaning the interior and accessories
- Cleaning the front of the appliance and the side panels
- Cleaning the ventilation gaps
- Cleaning the compressor and metal grille at the back of the appliance
- Cleaning the door seals
- Starting up the appliance after cleaning
- Replacing the charcoal filters
- Problem solving guide
- Noises
- Service
- Electrical connection
- Installation
- Changing the door hinging
- Aligning the appliance doors
Changing the door hinging
79
Lift the lower door off and place it
carefully to one side.
Changing over the lower hinge
plate
Pull the hinge pin complete with
washer and adjusting foot upwards to
remove.
Unscrew the hinge plate.
Remove the stopper from the
hinge plate.
Slightly loosen the screw of the
door closing aid on the hinge plate
.
Turn the door closing aid 90°
clockwise into the opposite hole in
the hinge plate.
Then tighten the screw.
Insert the stopper into the other
hole.
Remove the cover and refit on the
opposite side.
Screw the hinge plate onto the
opposite side with the screws ,
using only the outer two slots. Do not
use the middle screw . Otherwise
you will not be able to align the door
later on.
Reinsert the hinge pin complete
with washer and adjustable foot.
Important: The lug on the hinge pin
must point to the back again.