User's Manual
Table Of Contents
- Contents
- Warning and Safety instructions
- Caring for the environment
- How to save energy
- Guide to the appliance
- Accessories
- Before using for the first time
- Switching on and off
- The correct temperature
- Using SuperFreeze, SuperCool and DynaCool
- Temperature and door alarm
- Selecting further settings
- Settings overview
- Selecting further settings
- Explanation of the different settings
- Switching Party mode on/off
- Switching Holiday mode on/off
- Using the minute minder (QuickCool timer)
- – Setting the minute minder
- – When the minute minder duration has elapsed
- – Altering the minute minder
- – Cancelling the minute minder
- Activating or deactivating the safety lock /
- – Deactivating the safety lock temporarily
- – Switching off the safety lock
- Switching the appliance off
- Switching Sabbath mode on/off
- – Switching Sabbath mode on
- – Switching Sabbath mode off prematurely
- Setting the time before the door alarm is triggered
- Switching the keypad tone / on/off
- Setting the volume/Switching alarms and audible tones on/off
- Setting the display brightness
- Setting the temperature unit /
- Switching Demo mode off
- Resetting factory settings
- Accessing information
- – Displaying licence agreements
- Reminder to replace charcoal filter
- Using the refrigerator efficiently
- Adjusting the interior fittings (refrigerator section)
- Freezing and storing food
- Defrosting
- Cleaning and care
- Cleaning agents
- Preparing the appliance for cleaning
- Cleaning the interior and accessories
- Cleaning the front of the appliance and the side panels
- Cleaning the ventilation gaps
- Cleaning the compressor and metal grille at the back of the appliance
- Cleaning the door seals
- Starting up the appliance after cleaning
- Replacing the charcoal filters
- Problem solving guide
- Noises
- Service
- Electrical connection
- Installation
- Changing the door hinging
- Aligning the appliance doors
Changing the door hinging
80
Changing the middle hinge
plate over
Pull the cover off.
Unscrew the hinge plate with the
protective film underneath.
Turn the hinge plate 180° and
screw it into position with the
protective film on the opposite side.
The protective film protects the
appliance housing from damage.
Turn the grey plastic cap 180° and
refit it in the hinge plate.
Useful tip: The plastic cap fits over
the protruding bearing bush so that this
is covered from underneath and from
the side.
Turn the cover 180° and refit it on
the opposite side.
Preparing the doors
Useful tip: Place a suitable cover over
a stable surface to protect the
appliance door from damage. Place the
door on it with the outside facing down.
Carry out the following steps on both
doors.
Changing over the bearing bush
stopper
Pull the stopper out of the door
bearing bush and replace it on the
opposite side.