Installation Instructions
Table Of Contents
- Contents
- IMPORTANT SAFETY INSTRUCTIONS 5
- Guide to the Appliance 11
- How to save Energy 14
- Turning the Appliance On / Off 16
- The Right Temperature 18
- Using SuperCool in the refrigerator section 21
- Using SuperCool in the freezer section 22
- Temperature and Door Alarm 23
- Additional Settings 25
- Using the Refrigerator Efficiently 30
- Arranging the Interior - Refrigerator Section 32
- Freezing and Storing Food 34
- Making Ice Cubes 36
- Arranging the Interior - Freezer Section 39
- Defrosting 41
- Cleaning and Care 42
- Frequently asked questions 46
- Noises 54
- After sales service 55
- Caring for the environment 58
- Installation Information 59
- Installation Dimensions 62
- Niche Dimensions 64
- Door Swing Clearance 65
- Planning the Water Connection 66
- Information Concerning the door panel 67
- Installing the Appliance 69
- Installing the Appliance 69
- Installing the anti-tip brackets 69
- Fastening the covers 71
- Pushing the appliance into the niche 72
- Aligning the appliance 72
- Securing the appliance in the niche 73
- Aligning the appliance door 73
- Aligning the drawer front 74
- Install the base cover with the ventilation slits 74
- Removing the mounting rails 76
- Installing the mounting rails on the door panel 77
- Installing the door panel on the appliance door 77
- Installing the door panels on the freezer drawers 81
- Plumbing 82
- Electrical connection 86
- Contact details 91
Installation of the anti-tip bracket in a
cabinet with a depth greater than 25"
(635 mm)
The anti-tip bracket assures proper
functioning up to a cabinet depth of 24"
- 25" (610-635 mm). If the cabinet is
deeper than 25" (635 mm), a wooden
spacer is required between the back
wall of the niche and the appliance.
The spacer must be secured to the
floor.
Position of the spacer in a normal
cabinet
Position of the spacer in a frameless
cabinet
The anti-tip bracket must be level
after installation even if the floor is
not level. Install the wooden spacer
in an appropriate position.
Fastening the covers
Install the adhesive covers above,
between and under the mounting plates
on the sides of the appliance.
^ Cut the covers to the required length
(see illustration).
^ Fasten the covers keeping a 1/4"
(6 mm) clearance from the mounting
plates.
Installing the Appliance
71