Installation Instructions
Table Of Contents
- Contents
- IMPORTANT SAFETY INSTRUCTIONS 5
- Guide to the Appliance 11
- How to save Energy 14
- Turning the Appliance On / Off 16
- The Right Temperature 18
- Using SuperCool in the refrigerator section 21
- Using SuperCool in the freezer section 22
- Temperature and Door Alarm 23
- Additional Settings 25
- Using the Refrigerator Efficiently 30
- Arranging the Interior - Refrigerator Section 32
- Freezing and Storing Food 34
- Making Ice Cubes 36
- Arranging the Interior - Freezer Section 39
- Defrosting 41
- Cleaning and Care 42
- Frequently asked questions 46
- Noises 54
- After sales service 55
- Caring for the environment 58
- Installation Information 59
- Installation Dimensions 62
- Niche Dimensions 64
- Door Swing Clearance 65
- Planning the Water Connection 66
- Information Concerning the door panel 67
- Installing the Appliance 69
- Installing the Appliance 69
- Installing the anti-tip brackets 69
- Fastening the covers 71
- Pushing the appliance into the niche 72
- Aligning the appliance 72
- Securing the appliance in the niche 73
- Aligning the appliance door 73
- Aligning the drawer front 74
- Install the base cover with the ventilation slits 74
- Removing the mounting rails 76
- Installing the mounting rails on the door panel 77
- Installing the door panel on the appliance door 77
- Installing the door panels on the freezer drawers 81
- Plumbing 82
- Electrical connection 86
- Contact details 91
Installing the door panels on
the freezer drawers
^ Pull the upper freezer drawer out and
affix both sides of the door panel with
the screws 1/8'' x 1/16''
(3.5 x 13 mm).
^ Close the freezer drawer and check
the distance from the surrounding
door panels.
To vertically align the door panel with
the adjacent cabinetry doors,
^ loosen the screws on both sides and
adjust the position of the door panel.
^ Then tighten the screws.
Be careful not to over-tighten the
screws. Do not use a electric
screwdriver.
^ Now do the same on the lower
freezer drawer.
^ When finished, close the gap
between the freezer drawer and the
door panel with the supplied
adhesive seal.
^ Remove the protective foil from the
adhesive side of the seal and stick
the seal onto the upper edge of the
freezer drawer. Make sure that the
seal is properly positioned in the gap.
Installing the Appliance
81