Technical data

*Niche height
1= Side-by-Sidefittingkitincludingpre-installedsidewall
heating KSK 1002
2=Furnitureplinthheight102-132mm
(the appliance feet can be adjusted up to 30 mm high)
3= Totalappliancenichewidth1219mm
(457 mm + 762 mm)
K 1801 Vi and F 1471 Vi-1
MasterCool
Side-by-Side installation
1=Sidewallheater
Without partition wall between MasterCool appliances
If the appliances are to be installed next to each other without
a partition wall between them, merging kit KSK 1002 is
required.
Side-by-Side planning options
1=Sidewallheater
Installation with a partition wall without the Side-by-Side
installation kit
If the partition wall between the two appliances is more than
160 mm thick, each appliance must each be built into its own
niche using the assembly parts supplied (without using the
merging kit KSK 1002).
Installation with partition wall and with Side-by-Side
installation kit
If the partition wall between the two appliances is between 16
mm and 160 mm thick, each appliance must be built into its
own niche using the assembly parts supplied. The merging kit
KSK 1002 is also required.
KF 1911 Vi [mm] KF 1911 Vi [mm] KF 1911 Vi [mm]
KF 1911 Vi [mm]KF 1911 Vi [mm] KF 1911 Vi [mm]
A) Appliance door width: 982 mm
B) Furniture front (max. 38 mm)
C) Door handle
D) Distance between appliance door and the wall (excluding
furniture front and door handle): 428 mm
A) Appliance door width: 982 mm
B) Furniture front (max. 38 mm)
C) Door handle
For Side-by-Side installation
1=sidewallheater
Door front dimensions
N.B. Air vents must not be covered or blocked in any way.
The recommended thickness of furniture front is 1.9cm but
could be increased to 3.8cm. In this case the niche depth
has to be increased accordingly and maximum weight has to
be considered.
A 5 x 40 cm cut-out should be provided in the furniture housing unit where a 200 cm
2
ventilation gap is stipulated.
During periods of high humidity, some condensation may appear on outside surfaces of cooling appliances. This condensation will
disappear when humidity levels drop. For prevention it is advisable to install the appliance with sufficient ventilation in a dry and/or an air-
conditioned room. Please ensure that doors are closing and sealing properly.
Building-in diagrams: KF 1911 Vi
A) Niche Width : 915-918mm
86 87