Operating instructions

Control knobs
The control knob for each burner is used to ignite the burner
and regulate the strength of the flame.
ß The gas supply is turned off
& Strongest flame
/ Weakest flame
Switching on
^
To ignite the burner, the control for the burner required
must be pressed in and turned anti-clockwise to the large
flame symbol.
When a control knob is activated, a spark is generated on
all burners. This is normal and does not indicate a fault.
^ When a flame is visible, keep the control pressed in for
8-10 seconds, and then let it go.
^ If the flame goes out, turn the control to "ß" and wait for at
least 1 minute before trying to ignite it again. If necessary,
keep the control pressed in for longer.
If the burner does not ignite the second time, turn the control
to "ß" and see "Problem solving guide".
Switching on during a power outage
If there is an interruption to the electricity supply the gas can
be ignited manually, e.g. with a match.
^
Press in the relevant control and turn it anti-clockwise to the
large flame symbol.
^
Hold the control pressed in and light the gas at the burner
with a match.
Keep the control pressed in for a further 8-10 seconds and
then release it.
Operation
18