Operating instructions/Installation instructions
Table Of Contents
- Contents
- Warning and Safety instructions
- Caring for the environment
- Guide to the appliance
- Before using for the first time
- How it works
- Pans
- Tips on saving energy
- Setting range
- Operation
- Timer
- Additional functions
- Safety features
- Programming
- Note for test institutes
- Cleaning and care
- Problem solving guide
- Optional accessories
- After sales service
- Installation
- Product data sheets
Installation
*INSTALLATION*
69
Flush-fit installation
Create the worktop cut-out.
Remember to maintain the minimum
safety distances (see “Installation –
Safety distances”).
Solid wood, tiled and glass worktops:
Fix a wooden frame 7mm below the
top edge of the worktop (see the
diagram in “Installation” – “Installation
dimensions – Flush-mounted”).
Feed the mains connection cable for
the hob down through the worktop
cut-out.
Centre the hob in the cut-out.
The gap between the ceramic glass
surface and the worktop must be at
least 2mm wide. This is required so
that the hob can be sealed.
Connect the hob to the power supply.
Check that the hob works.
Seal the gap between the hob and
worktop with a silicone sealant that is
heat-resistant to at least 160°C.
Damage from unsuitable sealant.
Unsuitable sealant can damage
natural stone.
For natural stone worktops and
natural stone tiles, only use silicone
sealant that is specially formulated
for natural stone. Follow the
manufacturer’s instructions.