Operating and Installation instructions
Table Of Contents
- Contents
- IMPORTANT SAFETY INSTRUCTIONS
- Caring for the environment
- Saving energy
- Guide to the appliance
- Switching on and off
- The correct temperature
- Using Automatic SuperCool
- Door alarm
- Selecting additional settings
- Storing food in the refrigerator section
- Storing food in the PerfectFresh zone
- Adjusting the interior fittings
- Defrosting
- Cleaning and care
- Frequently Asked Questions
- Causes of noises
- Customer Service
- Information for dealers
- Installation
- Installation
- Installation dimensions
- Limiting the opening angle of the appliance door
- Changing the door hinging
- Building in the appliance
- Preparing the appliance
- With 5/8" (16 mm) thick cabinet walls only:
- Building in the appliance
- Securing the appliance in the niche
- Only for an appliance with a niche height greater than 55" (140 cm)
- Installing the cabinet door
- Adjusting the position of the door
- X: side adjustments
- Y: height adjustment
- Z: depth adjustment
- Electrical connection
Adjusting the interior fittings
42
Adjusting the bottle rack
The bottle rack can be placed at differ-
ent positions in the appliance.
Lift the bottle rack slightly at the front,
pull it forward a little, lift the recess
over the shelf supports, and move the
shelf up or down.
The stop bar at the back must face up-
ward to prevent the bottles from touch-
ing the back wall.
PerfectFresh drawers
The drawers in the PerfectFresh zone
are on telescopic rails, and can be re-
moved for filling, emptying, or cleaning
purposes:
To make it easier to pull out the draw-
ers, remove the bottle shelf from the
appliance door.
Pull the drawers out as far as they will
go.
Holding the sides of the drawer at the
back, lift it up and then pull it forward
and out.
Push the runners back in again to
avoid damaging them!
Carefully pull out the lid between the
drawers slightly, and lift it down and
out.
Be careful not to wash away the spe-
cial lubricant in the telescopic run-
ners during cleaning.
Wipe the telescopic runners with a
damp cloth to clean them.
To replace the drawer lid, insert it
from beneath into the holders, and
push it back until it clicks into place.
Inserting the fruit and vegetable drawer
Push the runners back in completely
and then place the drawers on them.
Push the drawer into the appliance
until it clicks into position.