Operating and Installation instructions
Table Of Contents
- Contents
- IMPORTANT SAFETY INSTRUCTIONS
- Caring for the environment
- Saving energy
- Guide to the appliance
- Switching on and off
- The correct temperature
- Using Automatic SuperCool
- Door alarm
- Selecting additional settings
- Storing food in the refrigerator section
- Storing food in the PerfectFresh zone
- Adjusting the interior fittings
- Defrosting
- Cleaning and care
- Frequently Asked Questions
- Causes of noises
- Customer Service
- Information for dealers
- Installation
- Installation
- Installation dimensions
- Limiting the opening angle of the appliance door
- Changing the door hinging
- Building in the appliance
- Preparing the appliance
- With 5/8" (16 mm) thick cabinet walls only:
- Building in the appliance
- Securing the appliance in the niche
- Only for an appliance with a niche height greater than 55" (140 cm)
- Installing the cabinet door
- Adjusting the position of the door
- X: side adjustments
- Y: height adjustment
- Z: depth adjustment
- Electrical connection
Cleaning and care
50
Starting up the appliance after
cleaning
Replace all shelves and accessories
in the appliance.
Reconnect to the power supply and
switch the appliance back on.
Switch on the automatic SuperCool
function for a while so that the refrig-
erator section can cool down quickly.
Put the food back in the appliance
and close the door.
Replacing the carbon filters
The carbon filter with KKF-FF holder
(Active AirClean) is available as an op-
tional accessory (see “Guide to the
appliance” section “Optional acces-
sories”).
Replace the carbon filters in the holder
around every 6months.
Replacement KKF-RFcarbon filters
can be obtained from Miele Customer
Service, from your dealer, or from
Miele’s website.
Tip: The carbon filter holder is dish-
washer safe.
Pull the carbon filter holder upward to
remove it from the adjustable shelf.
When in position, the carbon filters
must not touch the back wall of the
refrigeration appliance, as the mois-
ture could cause them to stick to it.
Insert the new carbon filters deep
enough in the holder to ensure that
they do not protrude over the edge
of the holder.