Operating and Installation instructions
Table Of Contents
- Contents
- IMPORTANT SAFETY INSTRUCTIONS
- Caring for the environment
- Saving energy
- Guide to the appliance
- Switching on and off
- The correct temperature
- Using Automatic SuperCool
- Door alarm
- Selecting additional settings
- Storing food in the refrigerator section
- Storing food in the PerfectFresh zone
- Adjusting the interior fittings
- Defrosting
- Cleaning and care
- Frequently Asked Questions
- Causes of noises
- Customer Service
- Information for dealers
- Installation
- Installation
- Installation dimensions
- Limiting the opening angle of the appliance door
- Changing the door hinging
- Building in the appliance
- Preparing the appliance
- With 5/8" (16 mm) thick cabinet walls only:
- Building in the appliance
- Securing the appliance in the niche
- Only for an appliance with a niche height greater than 55" (140 cm)
- Installing the cabinet door
- Adjusting the position of the door
- X: side adjustments
- Y: height adjustment
- Z: depth adjustment
- Electrical connection
Installation
*INSTALLATION*
80
Securing the appliance in the niche
Push the appliance onto the cabinet
wall on the hinge side.
Screw the particle board screws
through the hinge plates at the top
and bottom to secure the appliance
to the housing unit.
Push the loose securing bracket
against the cabinet wall.
Fix the securing bracket to the
cabinet wall with the screw.
Tip: Pre-drill the hole.
The appliance must not pull back
into the unit, as otherwise the gap of
1 5/8" (42mm) will not be maintained
all the way round.
Push the protruding bracket toward
the cabinet wall using your thumb
while tightening the screws.
Fix the securing bracket to the
cabinet wall with the screws.
Tip: Pre-drill the holes.
Re-tighten screws and .