Operating and Installation instructions
Table Of Contents
- Contents
- IMPORTANT SAFETY INSTRUCTIONS
- Caring for the environment
- Saving energy
- Guide to the appliance
- Switching on and off
- The correct temperature
- Using Automatic SuperCool
- Door alarm
- Selecting additional settings
- Storing food in the refrigerator section
- Storing food in the PerfectFresh zone
- Adjusting the interior fittings
- Defrosting
- Cleaning and care
- Frequently Asked Questions
- Causes of noises
- Customer Service
- Information for dealers
- Installation
- Installation
- Installation dimensions
- Limiting the opening angle of the appliance door
- Changing the door hinging
- Building in the appliance
- Preparing the appliance
- With 5/8" (16 mm) thick cabinet walls only:
- Building in the appliance
- Securing the appliance in the niche
- Only for an appliance with a niche height greater than 55" (140 cm)
- Installing the cabinet door
- Adjusting the position of the door
- X: side adjustments
- Y: height adjustment
- Z: depth adjustment
- Electrical connection
Installation
*INSTALLATION*
82
Installing the cabinet door
If installed in a run of units, make sure
that the top edge of the cabinet door
is at the same height as neighboring
unit doors.
The cabinet door must be installed
level, and not under tension.
The next section gives instructions on
how to install a cabinet door that is at
least 5/8" - 3/4" (16 - 19mm) thick.
The distance between the appliance
door and the mounting frame is set to
5/16" (8mm) at the factory. Check
this distance and adjust it if neces-
sary.
Push the installation aids to the
height of the cabinet door. The lower
contact edge X of the installation aids
must be at the same height as the
upper edge of the cabinet door to be
installed (symbol).
Tip: Push up the installation aids to-
gether with the cabinet front until they
are at the same height as the neighbor-
ing unit doors.
Unscrew the nuts and remove the
mounting frame together with the
installation aids.