Operating and Installation instructions
Table Of Contents
- Contents
- IMPORTANT SAFETY INSTRUCTIONS
- Caring for the environment
- Saving energy
- Guide to the appliance
- Switching on and off
- The correct temperature
- Using Automatic SuperCool
- Door alarm
- Selecting additional settings
- Storing food in the refrigerator section
- Storing food in the PerfectFresh zone
- Adjusting the interior fittings
- Defrosting
- Cleaning and care
- Frequently Asked Questions
- Causes of noises
- Customer Service
- Information for dealers
- Installation
- Installation
- Installation dimensions
- Limiting the opening angle of the appliance door
- Changing the door hinging
- Building in the appliance
- Preparing the appliance
- With 5/8" (16 mm) thick cabinet walls only:
- Building in the appliance
- Securing the appliance in the niche
- Only for an appliance with a niche height greater than 55" (140 cm)
- Installing the cabinet door
- Adjusting the position of the door
- X: side adjustments
- Y: height adjustment
- Z: depth adjustment
- Electrical connection
Installation
*INSTALLATION*
86
Z: depth adjustment
Check the distance between the cabi-
net door and the housing unit. A dis-
tance of approximately 1/16" (2mm) is
required.
Loosen screws and .
Tighten all the screws again.
Replace the cover and click it into
place.
Close the covers on the securing
brackets.
The appliance is properly installed in
the niche if:
- the door closes properly
- the door does not touch the housing
unit
- the seal on the top corner of the han-
dle side is firmly seated
To double check place a flashlight in
the appliance and close the door.
Turn the lights out in the room. If you
can see any light shining out from the
sides, double check the individual in-
stallation steps.