Operating instructions/Installation instructions

The optimum temperature and air quality
27
Safety device in case of low ambient
temperatures
The appliance is equipped with a safety
thermostat to protect your wine against
a sharp drop in temperature. If the ex-
ternal temperature should fall, a heater
element switches on automatically to
keep the temperature inside as constant
as possible. If the ambient temperature
continues to fall, the appliance switches
itself off automatically.
Setting the temperature
 Use the two sensors underneath the
display to set the temperature.
By touching the sensor
- The temperature decreases.
- The temperature increases.
 Touch the OK sensor to confirm your
selection
or
 wait approximately 5 seconds after
the last touch of a sensor.
The temperature being set will flash in
the display.
The following information shows in the
display while the sensors are being
touched:
- Touching a sensor once: the last
temperature selected flashes.
- Each subsequent touch of the
sensor: adjusts the temperature
shown in 1°C increments.
- Leaving a finger on the sensor
changes the temperature continu-
ously.
A tone will sound (if the sensor tone
is switched on) when the lowest or
highest possible temperature is
reached.
Approximately 5 seconds after the last
time a sensor has been touched, the
current temperature inside the wine
conditioning unit is automatically
shown.
When the temperature is altered, there
is a short delay until the temperature
selected is set.
The temperature display on the control
panel always shows the actual tem-
perature.