Owners Manual
Table Of Contents
- Contents
- IMPORTANT SAFETY INSTRUCTIONS 5
- Guide to the appliance 10
- Accessories 13
- Emergency door opener 14
- How to save energy 15
- Turning the appliance on and off 16
- Selecting additional settings 18
- Temperature and air quality 21
- Temperature and door alarm 26
- Feature lighting 28
- Storing wine bottles 30
- Sommelier set 35
- Automatic defrosting 37
- Cleaning and Care 38
- Active charcoal filter 41
- Frequently asked questions 43
- Noises 48
- After sales service 49
- Information for dealers 50
- Caring for the environment 53
- Electrical connection 54
- Installation 56
- Adjusting the door hinge 61
- Under-counter installation 65
- Contact details 76
The selected brightness is saved and
the temperature reappears in the
display.
As soon as the appliance door is
closed, the set brightness for the
feature lighting takes effect. When the
appliance door is opened, the interior
lighting returns to its normal level.
Lighting duration of the feature
lighting
The lighting duration for the feature
lighting is set to 30 minutes at the
factory.
The lighting duration can be set to 30,
60, 90 minutes, up to 00 (unlimited).
The feature lighting will have the
brightness setting you have selected
previously.
^ Open the appliance door.
^
Tap the On/Off sensor button for the
feature lighting so that it is
highlighted in yellow.
^
Tap the sensor button for the feature
light again (about two seconds long),
until ^ flashes in the display.
^
Use the X and Y sensor buttons for
altering the temperature to set the
feature lighting duration.
The duration (in minutes) will flash in
the display.
By touching the button:
–
lighting duration is reduced by 30
minutes
–
lighting duration is increased by 30
minutes
^ Tap the OK button to confirm your
choice.
The selected lighting duration is saved.
The temperature reappears in the
display.
The lighting duration set starts anew
whenever the appliance door is opened
and closed.
Do not remove the lighting covers.
Should the covers be damaged or
need to be removed due to
damage, use caution. There are
lasers in the lighting (laser beam
class 1M) which you should avoid
looking at directly. Do not use
optical instruments (magnifying
glass or similar) to look at the
lighting.
Feature lighting
29