Operating and Installation Instructions
Table Of Contents
- Contents
- IMPORTANT SAFETY INSTRUCTIONS
- Caring for the environment
- Saving energy
- Guide to the appliance
- Accessories
- Switching the wine conditioning unit on and off
- Selecting additional settings
- Optimum temperature and air quality
- Temperature and door alarm
- Feature lighting
- Storing wine bottles
- SommelierSet
- Automatic defrosting
- Cleaning and care
- Active AirClean filter
- Frequently Asked Questions
- Causes of noises
- Technical Service
- Installation
- Information for dealers
Frequently Asked Questions
55
Messages in the display
Message Possible cause and solution
The alarm symbol is
lit up in the display and
both wine conditioning
zone sensors flash in
the control panel. An
audible alarm is also
sounding.
The door alarm has been activated.
Close the wine unit door. Both wine conditioning
zone sensors and the alarm symbol will go out
and the acoustic alarm will stop.
The alarm symbol is
flashing in the display,
and the sensor for one
of the wine conditioning
zones is also flashing.
An alarm also sounds.
The temperature in the zone concerned has risen
higher or fallen lower than the temperature set.
Possible reasons for this include:
– The appliance door was opened too frequently.
– The ventilation gaps have been blocked.
– A prolonged power failure has occurred.
Rectify the cause of the alarm. The alarm sym-
bol goes out and the sensor for the affected
wine conditioning zone lights up again constantly.
The alarm stops.
The Change Active Air-
Clean filter symbolis
lit up.
This is the reminder to change the Active AirClean fil-
ter.
Replace the Active AirClean filter and then confirm
the filter change in settings mode (see “Active Air-
Clean Filter”).
A dash is lit up up/flash-
ing in the display.
Only temperatures within the range of the appliance
temperature will be displayed.
“F0”, “F1” or“E1” to “E8”
appears in the display.
There is a fault.
Contact the Service department.