Operating instructions/Installation instructions

Table Of Contents
Problem solving guide
59
Many malfunctions and faults that can occur in daily operation can be easily
remedied. Time and money will be saved because a service call will not be
needed.
The following guide may help you to find the reason for a malfunction or a fault,
and to correct it.
Problem Cause and remedy
A programme will not
start.
Check whether:
the appliance door is closed.
the system lock has been activated (see “System
lock” section in the “Operation” chapter).
door” has appeared in the display. The door has
not been opened for a long time (approx.
20minutes) (see “door message” section in the
“Operation” chapter).
the appliance is plugged into the electricity supply
and switched on at the socket.
the mains fuse has tripped. If it has, there could be
a fault with the appliance, the household electricity
supply or another appliance (disconnect the appli-
ance from the electricity supply and contact a
qualified electrician or the Miele Customer Service
Department, see “Customer service” chapter).
A noise can be heard
after a cooking pro-
gramme.
This is not a fault. The cooling fan will continue to
run for a while after the oven has been switched off
to prevent any humidity building up in the oven
compartment, on the control panel or on the oven
housing unit. It will switch off automatically.
The display does not
light up.
The time of day display has been switched off.
Press and hold the button for several seconds.
Night time switch-off is activated.
Deactivate it.
The turntable does not
turn smoothly.
The area underneath the turntable could be dirty.
Check whether there is any soiling underneath the
turntable.
Check whether the surfaces between the turntable
and the roller ring are clean.
Clean the area underneath the turntable.