User manual

Setup and connection
*INSTALLATION*
16
Electrical connection
 Risk of injury caused by a faulty
appliance.
Before connecting the appliance, en-
sure that it has not been damaged in
any way.
Never use a faulty appliance.
The appliance is supplied ready for
connection with a cable and plug.
Ensure that the protective contact
socket is easily accessible at all times.
If that is not possible, ensure that a
suitable means of disconnection is
provided on the installation side for
each pole.
 Fire hazard due to overheating.
Connecting the appliance to a multi-
socket plug adapter or to an exten-
sion lead can overload the cable.
For safety reasons, do not use an ex-
tension lead or multi-socket plug ad-
apter.
Connect the appliance directly to the
power supply using the original cable
and do not use any intermediate ele-
ments.
The electrical installation must comply
with VDE0100 requirements and local
regulations (e.g. BS 7671 in the UK).
If the connection cable is damaged, it
must only be replaced with a specific
connection cable of the same type
(available from the Miele Customer Ser-
vice Department). For safety reasons,
such replacement may only be carried
out by a qualified technician or the
Miele Customer Service Department.
The necessary connection data can be
found on the data plate located on the
front of the oven interior or on the back
of the appliance.
Compare the specifications on the data
plate with those of the electricity sup-
ply. Make sure that they match.
If in any doubt, consult a qualified elec-
trician.
The appliance must not be connected
to the inverter of an autonomous power
supply, such as a solar power system.
When the appliance is switched on,
power surges could result in a safety
switch-off. This could damage the elec-
tronic module.
The appliance must not be used with
so-called energy-saving devices. These
reduce the amount of energy supplied
to the appliance, causing it to overheat.