Operating instructions/Installation instructions
Table Of Contents
- Contents
- IMPORTANT SAFETY INSTRUCTIONS 4
- Appliance description 16
- Before first use 19
- Principle of operation 20
- Functions 21
- Suitable cookware for microwave ovens 22
- Clock display 26
- Operation 27
- Using the automatic programs 33
- Recipes for automatic programs 2 36
- Saving your favorite programs 39
- Changing settings 41
- Reheat 44
- Cooking 45
- Defrosting / Defrosting and reheating or cooking 46
- Canning 47
- Suggested uses 48
- Cleaning and care 49
- Frequently Asked Questions 53
- After sales service 55
- Caring for the environment 58
- Electrical connection 59
- Installation 60
- Contact details 63
Interrupting or resuming a
program
At any time you can...
...interrupt a program:
^
Touch the UU UU button, or open the
appliance door.
The time stops counting down.
...resume a program:
^ Close the door and touch the "Start"
button.
The program will continue.
Changing the settings
After starting the program, if you
determine that...
...themicrowave power level is too
high or too low:
^
Select a new power level.
...thetime entered is too short or too
long:
^
Interrupt the program (touch the UU UU
button), use the selector knob to set
a new time, and resume the program
(touch the "Start" button),
or alternatively:
^
Use directly the selector knob to set
a new time, and resume the program
(touch the "Start" button),
or alternatively:
^
Touch the "Start" button during
operation to increase the cooking
time. Each touch of the button
increases the time by another minute.
(Exception: The time increases by 30
seconds when the microwave oven is
being used at maximum power.)
Cancelling a program
^
Touch the UU UU button, or open the
appliance door.
The time stops counting down.
^ Touch the # button.
At the end of a program
A signal will sound when the cooking
program is complete. The oven interior
lighting goes out.
The signal repeats several times. Then,
a brief reminder signal sounds at
regular intervals for a period of time
following the end of the program. It is
possible to deactivate these functions
(see "Changing settings").
^
If you would like to stop the signal,
touch the # button.
Operation
29