install guide
Before using for the first time
19
3. Removing the shipping
struts
Failure to remove the shipping
struts can result in damage to the
washing machine and to adjacent
cabinetry or appliances.
Remove the shipping struts as
described in the "Installation"
section.
The following message appears in the
display:
Remove shipping struts
Confirm with the OK sensor button.
4. Commissioning TwinDos
The UltraPhase1 and UltraPhase2
values are pre-set in the standard
settings and only need to be confirmed.
The following message appears in the
display:
TwinDos
Confirm with OK.
The following message appears in the
display:
Set now
To set up TwinDos now: Touch the
OK sensor button.
To postpone setup until later: Touch
the sensor button until the
following appears in the display: Set
up later and press the OK button to
confirm.
Settings for compartment
The UltraPhase1 values are pre-set in
the standard settings.
Agent for
OK
Confirm with the OK sensor button.
Miele UltraPhase 1
OK
Confirm with the OK sensor button.
The following will appear in the display:
Set the dosage. Observe water hardness
levels
Confirm with the OK sensor button.
The dispensing quantity for
UltraPhase1 for (hardness level I)
is pre-set.
Per load
OK
ml
48
Confirm the pre-set value with the OK
sensor button or correct the value
with the sensor buttons and
confirm this with the OK sensor
button.
UltraPhase1
Hardness level I 48ml
Hardness level II 60ml
Hardness level III 72ml