Operating instructions/Installation instructions
Table Of Contents
- Contents
- Caring for the environment
- IMPORTANT SAFETY INSTRUCTIONS
- Operating the tumble dryer
- Initial commissioning
- 1. Notes on correct laundry care
- 2. Loading the tumble dryer
- 3. Selecting a program
- 4. Selecting program settings
- 5. Starting a program
- 6. End of program – removing the laundry
- Timer
- Program chart
- Changing the program sequence
- Fragrance flacon
- Cleaning and care
- Frequently Asked Questions
- Customer Service
- MIELE
- IMPORTANT SAFETY INSTRUCTIONS
- Installation and connection
- Technical data
- Supervisor level
Cleaning and care
58
Cleaning the filter insert (in the
toe-kick)
The surface of the filter in the filter
insert is visible after removing the lint
filter in the toe-kick. This filter surface
must only be cleaned if there is a visible
accumulation of lint.
Carefully vacuum up any visible lint or
soiling. Use a dusting brush or the
narrow crevice nozzle.
If there are visible blockages or other
residues after cleaning: Remove the
filter insert and clean it under running
water. If stubborn residues are not
removed, these can lead to faults
over time.
Removing the filter insert
If the filter insert is clogged up and
soiled, it must be removed and cleaned
under running water.
Use the handle to pull out the filter
insert at an angle forward and to the
right.
Then pull the filter insert out at an
angle.
Rinse the filter surface of the insert
under warm running water.
Wet lint filters could cause
operational faults while drying.
Shake the filter insert thoroughly and
then dry it carefully.