Operating instructions/Installation instructions
Table Of Contents
- Contents
- Caring for the environment
- IMPORTANT SAFETY INSTRUCTIONS
- Operating the tumble dryer
- Initial commissioning
- 1. Notes on correct laundry care
- 2. Loading the tumble dryer
- 3. Selecting a program
- 4. Selecting program settings
- 5. Starting a program
- 6. End of program – removing the laundry
- Timer
- Program chart
- Changing the program sequence
- Fragrance flacon
- Cleaning and care
- Frequently Asked Questions
- Customer Service
- MIELE
- IMPORTANT SAFETY INSTRUCTIONS
- Installation and connection
- Technical data
- Supervisor level
Frequently Asked Questions
Message Possible cause and solution
Rinse the lint filter
and plinth filter.
Check the airways.
The plinth filter looks clean after thorough cleaning.
However, the program is canceled and the fault
message appears again. The reason for this is that
there is still underlying residue that cannot be
removed.
To delete the message: touch the OKsensor
control.
Replace the plinth filter with a new one.
You can reactivate the removed, “old” plinth filter
in the washing machine. Follow the instructions
described in “Frequently Asked Questions” –
“Reactivating the plinth filter”.
Check water drain
The condensate drain is faulty.
Check that the drain hose is in good working order
and is not bent.
To delete the message: open and close the door
while the tumble dryer is switched on.
Fault F. If restart
fails, contact Ser-
vice.
There is no obvious cause for the cancellation of the
program.
Note the prompt in the display.
Touch the OKsensor control.
Start a drying program.
If the program terminates again with the same fault
message, then there is a fault. Contact Miele
Customer Service.
67