Operating and Installation Instructions
Table Of Contents
- Contents
- Caring for the environment
- IMPORTANT SAFETY INSTRUCTIONS
- Operating the tumble dryer
- Initial commissioning
- 1. Notes on correct laundry care
- 2. Loading the tumble dryer
- 3. Selecting a program
- 4. Selecting program settings
- 5. Starting a program
- 6. End of program – removing the laundry
- Timer
- Program chart
- Changing the program sequence
- Fragrance flacon
- Cleaning and care
- Frequently Asked Questions
- Technical Service
- MIELE
- IMPORTANT SAFETY INSTRUCTIONS
- Installation and connection
- Technical data
- Supervisor level
Frequently Asked Questions
Message Possible cause and solution
Check water drain
lights up after a
program has
been canceled.
The condensate drain is faulty.
Check that the drain hose is in good working order
and is not bent.
To delete the message: Open and close the door
while the tumble dryer is switched on.
Plinth filter not fitted.
Please fit it.
The toe-kick filter has not been inserted.
Check the filter in the toe-kick.
Removing the filter during a drying program will
result in the program being canceled.
Fault F. If restart
fails, contact Ser-
vice.
lights up after a
program has
been canceled.
There is no obvious cause.
Note the prompt in the display.
Touch the OKsensor control.
If the program terminates again with the same error
message, then there is a fault. Contact Miele
Technical Service.
Obstruction de-
tected. Untangle
laundry and restart
lights up after a
program has
been canceled.
The laundry is unevenly distributed or has rolled up.
Open the door and loosen the laundry. Take out
some of the laundry if necessary.
Close the door.
Start a program.
Finish/Cooling downlights
up and the drying
process is not yet fin-
ished.
This is not a fault. The laundry is still being cooled.
The program is just about to end.
You can remove the laundry and spread it out to
cool down or leave it in the tumble dryer to cool
down until the end of the program.
69