Operating and Installation Instructions
Table Of Contents
- Contents
- Caring for the environment
- IMPORTANT SAFETY INSTRUCTIONS
- Operating the tumble dryer
- Initial commissioning
- 1. Notes on correct laundry care
- 2. Loading the tumble dryer
- 3. Selecting a program
- 4. Selecting program settings
- 5. Starting a program
- 6. End of program – removing the laundry
- Timer
- Program chart
- Changing the program sequence
- Fragrance flacon
- Cleaning and care
- Frequently Asked Questions
- Technical Service
- MIELE
- IMPORTANT SAFETY INSTRUCTIONS
- Installation and connection
- Technical data
- Supervisor level
Frequently Asked Questions
The drying-cycle duration is very long
Problem Possible cause and solution
The drying process
goes on too long or
even switches off*.
The room where the tumble dryer is located is too
warm.
Ventilate the room thoroughly.
Detergent residues, hair, and fine lint can clog the
filters.
Clean the lint filters and the filter in the toe-kick.
See “Cleaning and care” for an in-depth
description.
If you have removed the toe-kick filter, also check
the filter insert behind it. Clean it if necessary.
If you have removed the filter insert, also check the
heat exchanger behind it. Clean it if necessary.
The cooling fins behind the bottom-right grille are
soiled.
Clean as described in “Bottom-right grille/airways”
under “Cleaning and care”.
The laundry is too damp.
Spin using a higher spin speed in the washing
machine.
The drum is too full.
Do not exceed the maximum load for the program
selected.
Metallic components, e.g., zippers, have prevented
the dryer from registering the correct moisture level.
Open the zippers next time.
If the problem recurs, dry these items using the
Timed drying warm air program.
* Switch the tumble dryer off and on again before starting a new program.
71