Installation Plan Heat-Pump Dryer PDR 908 HP Always read the operating and installation instructions before setting up, installing, and commissioning the machine. This prevents both personal injury and damage to the machine.
Please have the model and serial number of your machine available when contacting Technical Service. U.S.A. Miele, Inc. National Headquarters 9 Independence Way Princeton, NJ 08540 Phone: 800-991-9380 Fax: 609-419-4241 www.miele-pro.com proinfo@mieleusa.com Technical Service & Support Phone: 800-991-9380 Fax: 800-220-1348 proservice@mieleusa.
PDR 908 HP en-US Machine dimensions F F F SLA F KGA F EL XKM F ASK F F PA 11 278 880/03 3
PDR 908 HP en-US Installation ASK EL KG EL ASK KG KGA SLA ASK EL KG EL ASK KG KGA SLA UO/ UG 4 11 278 880/03
PDR 908 HP en-US Installation F F F EL EL F KGA SLA ASK PA APCL ASK APCL 11 278 880/03 5
PDR 908 HP en-US Installation 6 11 278 880/03
PDR 908 HP en-US Technical data PDR 908 HP Heat pump Drying system Drum volume gal (l) 34.3 (130) Capacity lb (kg) 17.6 (8.0) Door opening diameter inch (mm) 14 9/16" (370) Electrical connection (EL) Standard voltage CND & USA 2 AC 208-240 V Frequency Hz 60 Total rated load kW 1.2 Fuse rating A 2 x 30 Wire min.
PDR 908 HP en-US Technical data PDR 908 HP Anchoring (B) Anchoring of Miele Plinths Miele Plinth installation (fasteners included) Required anchor points No. 4 Wood screws according to DIN 571 inch (mm) 8 x 65 Rawl plugs (diameter x length) inch (mm) 12 x 60 Min.
PDR 908 HP en-US Installation and planning notes Installation requirements Drainage options: The tumble dryer should only be connected to a power supply provided in accordance with all appropriate local and national legislation and regulations. 1. Direct connection to a plastic drain pipe with a rubber sleeve. Use a non-return valve if the end of the hose could possibly become submerged in water.
PDR 908 HP en-US Installation and anchoring The machine must be installed on a perfectly smooth, level, and firm surface which is able to withstand the quoted loads. The floor load created by the machine is concentrated and transferred to the installation footprint via the machine feet. The tumble dryer should be leveled in both directions with the aid of the adjustable feet.