Instructions

Problem solving guide
62
The dishwasher does not fill/drain
Problem Possible cause and remedy
One of the following
messages appears in
the display:
Turn on the tap The tap is turned off.
 Turn on the tap fully.
Water intake Before rectifying the problem, you must:
 Switch the dishwasher off with the button.
Water intake is restricted.
 Turn on the tap fully and start the programme
again.
 Clean the water inlet filter (see “Maintenance”).
 The water pressure at the intake is lower than
50kPa (0.5bar).
Seek professional advice.
The following fault
message appears in the
display:
Drain
Before rectifying the problem, you must:
 Switch the dishwasher off with the button.
The water outlet is restricted.
There might be water in the wash cabinet.
 Clean the filter combination (see “Cleaning and
care - Cleaning the filters”).
 Clean the drain pump (see “Maintenance”).
 Clean the non-return valve (see “Maintenance”).
 Remove any kink or loop in the drain hose.