Instructions

Water connection
74
– The water pressure (flow pressure at
the connection point) must be
between 50 and 1000kPa (0.5 and
10bar).
If the water pressure is lower than
this, the fault message Water intake
will appear in the display (see
“Problem solving guide”).
If the water pressure is too high, a
pressure reducing valve must be
fitted.
– A tap with a
3
/
4
inch male thread must
be provided on site. It should be
easily accessible so that the water
supply can be turned off when the
dishwasher is not in use.
– The DN 10 inlet hose is approx. 1.5m
long terminating in a
3
/
4
inch female
thread. A 1.5m long flexible metal
extension hose tested to 14,000kPa
(140bar) is available as an optional
accessory if required. Under no
circumstances must the inlet filter or
the flow regulator in the connection
be removed.
 To avoid any damage to the
machine, the dishwasher must only
be connected to a fully vented
plumbing system.
 The inlet hose must not be
shortened or damaged in any way as
it contains electrical components
(see illustration).