Operating instructions

This machine must only be installed and
commissioned by a Miele authorised
technician. In the U.K. gas heated
machines must be installed by a Corgi
registered fitter only.
Please observe the installation instructions
and the installation diagram supplied with
the machine. They are important for the
correct setting up and connection of the
machine.
,
The machine must not be transported
without its transport pallet in position.
Do not install the machine in a room where
there is a risk of frost occurring.
To ensure suitable access is maintained for
future maintenance and service work please
ensure that the minimum distances between
the machine and the wall specified on the
installation diagram are strictly observed.
Levelling the machine
This machine does not require a plinth. It
must, however, be aligned horizontally to
compensate for any unevenness in the floor.
Otherwise the correct functioning of the
machine may be impaired.
The screw feet (A) can be adjusted to align
the machine.
After aligning the machine correctly you
need to use a screwdriver to secure discs
(B) to the floor plate.
This dryer is fitted with an exhaust fan which
can be heard during operation.
If this noise disturbs you it is possible to fit a
silencer into the dryer's exhaust duct. These
are available from retail outlets.
Coin mechanism
This dryer can be fitted with a coin
mechanism.*
To do so a suitable adapter* is required. The
machine also has to be reprogrammed by a
Miele trained service technician.
All parts marked * are available from your
Miele Dealer or the Miele Spare Parts
Department.
Notes for the installer
M.-Nr. 06 533 441 29