Operation Manual

To set Special programmes
Special programmes must first be activated under the
Target groups setting.
Settings
Special
programmes
Back A
S.prog1
S.prog2
S.prog3 H
^
Select S.prog1, 2, 3, 4 or 5.
Settings
Special
programmes
Back A
Res. moisture prog.
Timed programme
^
Decide whether you want to select a residual
moisture or a timed programme.
1. To save the programme name
Save programme name: S.prog1
Delete Continue Back A
H H
H
^ Confirm Delete to change the programme name.
^ Confirm Delete again until the characters you wish
to delete have been removed.
Save programme name: DRY+_ _ _
ABCDEFGHIJKLMNOPQRSTUVWXYZ
0123456789ÄÖÜ/+ -._
abc Delete Continue Back A
HHH
H
^
Turn the multi-function selector to move the cursor
to the character line.
^
Using the multi-function selector, select and
confirm each letter or symbol in turn to create the
programme name.
A maximum of 7 characters may be entered.
–
abc/ABC
To select lower or upper case letters (short-cut
button D)
–
Delete
Deletes the last character entered (short-cut button
E)
–
Continue
To finish entering text (short-cut button F)
To go directly to the individual programme creation
system (see below)
–
Back
Back to the level above (short-cut button G)
2. Individual programme creation system
You can define the programme features by
changing the basic settings.
Enter the names of your special programmes and
their basic settings into the "Special programmes"
table in the "Programme chart" in this booklet.
Residual moisture programme
Final residual moisture level
–
from - 6% (dry) to 40% (damp).
Additional drying time
–
from 0 to 60 minutes.
Temperature (of process (drying) air):
–
from cold to 60°C
Main drum direction:
–
from 0 to 500 seconds.
Reverse drum direction:
–
from 0 to 500 seconds.
Timed programme
Duration
– up to 120 minutes, in various minute steps.
Temperature (of process (drying) air):
– from cold to 60°C
Main drum direction:
– from 0 to 500 seconds.
Reverse drum direction:
–
from 0 to 500 seconds.
Demo programme
This can be used by dealers to demonstrate the
dryer in their showrooms.
The controls are operated in the same way as they
would be in normal use.
However, the dryer will not heat up, and fault
messages and the operating hours counter will not be
displayed.
–
Off (factory default)
–
On
^
To switch on or off, press OK until information is
displayed.
Settings/Supervisor level menu
29