Technical data

Maximum final spin speed
Programme rpm
Sluice High 1400
Sluice Low 1400
Cottons hygiene 1400
Cottons universal 1400
Minimum iron 1000
Delicates 600
Quick wash 1400
Woollens 1200
Silks 400
Shirts 600
Disinfection programmes* 1400
Kitchen linen* 1400
Table linen* 1200
Curtains* 400
Pillows* 1400
Outerwear* 900
Proofing* 800
Denim 900
Towelling 1400
Separate rinse 1200
Starch 1400
Spinning 1400
* = These programmes are only
available if they have been activated
via the
Settings / Supervisor level .
You can reduce the final spin speed.
However, you cannot select a final spin
speed higher than that shown in the
chart above.
Rinse and interim spin
There is a spin after the main wash and
between the rinses. A reduction in the
final spin speed will also reduce the
interim spin speed.
To omit the final spin (Rinse hold)
^
Select
Rinse hold from the Extras
sub-menu. The laundry will not be
spun and will remain suspended in
the final rinse water. This reduces
creasing if the laundry is not going to
be removed from the drum immedi
-
ately after the end of the programme.
–
To start the final spin
:
The washing machine will display the
maximum spin speed possible. You
can select a spin speed lower than
this. Start the final spin by pressing
the
Start button.
– To end the programme
:
Press the a button. The water will
drain away. Press the door button a
again, to open the door.
To omit the spin between rinses and
the final spin
^ Select
Without spin from the Extras
sub-menu . The laundry is not spun
after the final rinse. The water will
drain away and the machine will go
straight into the anti-crease stage.
Spinning
23