Operating instructions/Installation instructions
Table Of Contents
- Contents
- Caring for the environment
- IMPORTANT SAFETY INSTRUCTIONS
- Operating the washing machine
- Initial commissioning
- Emptying the drum
- Switching on the washing machine
- Setting the display language
- Reference to external appliances
- Setting the display brightness
- Setting the date
- Confirming the time request
- Setting the time
- Selecting program packages
- Setting up a payment system
- Selecting pre-wash water
- Selecting main wash water
- Removing the shipping struts
- Completing the commissioning process
- 1. Preparing the laundry
- 2. Loading the washing machine
- 3. Selecting a program
- 4. Selecting program settings
- 5. Adding detergent
- 6. Starting a program – end of a program
- Timer
- Program chart
- Extra options
- Special features in the program sequence
- Changing the program sequence
- Cleaning and care
- Frequently asked questions
- Technical Service
- MIELE
- Installation and connection
- Technical data
- Supervisor level
Frequently asked questions
56
Program cancellation and error message
Problem Possible cause and solution
Drainage fault. Clean
drain filter and pump.
Check the drain
hose.
The drain is blocked or restricted.
The drain hose has been fixed too high.
Clean the drain filter and the drain pump.
The maximum drain height is 3' 3 3/8" (1m).
Water intake fault.
Open the water sup-
ply.
The water intake is blocked or restricted.
Check whether the water supply is turned on prop-
erly.
Check whether the intake hose is kinked.
The water pressure is too low.
Switch on the Low water pressuresetting (see “Low
water pressure” under “Supervisor level”).
The filters in the water intake are blocked.
Clean the filters (see “Cleaning the filters” under
“Cleaning and care”).
Waterproof system
activated.
The water protection system has reacted.
Turn off the water supply.
Contact Technical Service.
Disinfection temper-
ature not reached
The required temperature was not reached during the
disinfection program.
The washing machine has not carried out the dis-
infection cycle correctly.
Start the program again.
Fault F. If restart
fails, contact Ser-
vice.
There is a fault.
Disconnect the washing machine from the power
supply.
Wait at least 2minutes before reconnecting the
washing machine to the power supply.
Switch the washing machine on again.
Start the program again.
If the fault message appears again, contact Tech-
nical Service.